Cycle Command

Bobby · Post by **Bobby** » Mon Dec 15, 2003 4:02 pm

I was wondering if anyone had a command that you can use dcc chat like .cycle #channel, and it makes the bot part the channel, then rejoin.

Post by **caesar** » Mon Dec 15, 2003 4:14 pm

Either use one of the folowing commands:
1.
.dump part #channel

2.
.chanset #channel +inactive
.chanset #channel -inactive

or make an tcl script that will do that +inactive and -inactive via the "channel set" in TCL. Consult the tcl-commands.doc file for instructions and/or do a lil forum Search, cos this have been discussed before and an solution If I recall corectly had been offered.

TALES · Post by **TALES** » Wed Dec 17, 2003 12:10 pm

when the bot has no ops there is a msg cmd like:

Code: Select all

/msg botnick go #channel

then it wil cycle the channel to get ops but its will cycle the channel