download

Post by **caesar** » Fri Nov 22, 2002 7:39 am

I would like to use a pub/msg command and the eggdrop to download a file from the address I tell it and put it in the scripts/ dir. I'm not familiar only with the downloading part. Any1 can tell me how to make this part? Thanks in advance.

Photon · Post by **Photon** » Fri Nov 22, 2002 10:53 am

I would assume slennox would know this, seeing as I presume thats what the netupdate component of his botnet scripts does.

A good place to start would ge one of the http scripts in the archive methinks ... but I dont know if any of them allow specification of the target dir (not used 'em meself..)

Post by **caesar** » Fri Nov 22, 2002 12:38 pm

I will not mind if it's an non specific page, only if I can change the file name to download.

Photon · Post by **Photon** » Fri Nov 22, 2002 12:52 pm

http://www.egghelp.org/tclhtml/1256-0-1-HTTP.htm

I think its the one by firegl that everyone uses... comes with instructions IIRC, otherwise there are loads of references to it on this site.

Post by **caesar** » Fri Nov 22, 2002 1:00 pm

And wich one to get? I haven't seen something to satisy my need..

The HTTP server for eggdrop?

Photon · Post by **Photon** » Fri Nov 22, 2002 1:13 pm

DOH!

sorry, from within that file

# 1. Get tclhttpd2.2.1.tar.gz (or later) from one of these locations:
# ftp://ftp.scriptics.com/pub/tcl/httpd/

That seems to be the thing you're looking for!

Post by **caesar** » Sat Nov 23, 2002 2:40 pm

Humm.. That is a HTTP server for eggdrop and I'm not shure that will help me. I'll give it a try anyway..

tainted · Post by **tainted** » Sun Nov 24, 2002 12:38 am

Worst to worst, you cuold always just write a little exec script to wget <file> and specify ~/eggdrop/scripts/ to place the file.