egghelp/eggheads community

use-exempts

2004-12-11T17:05:59-04:00

the net type is set to 1,

the network i'm on is kreynet wich support +e and +I modes .. the bot just doesn't allow me to set .+invites or .+exempts becaose it always says use-exempts etc has to be enabled...

Statistics: Posted by CosmicD — Sat Dec 11, 2004 5:05 pm

use-exempts

2004-12-11T16:58:49-04:00

What network are you on, and are +e/+I valid channel modes? What do you have the variable set net-type as? Read this thread.

Statistics: Posted by YooHoo — Sat Dec 11, 2004 4:58 pm

use-exempts

2004-12-11T16:07:24-04:00

hello,

I've been recently trying to configure a bot. all of the scripts work ok and i've been searching for the befor mentioned problem too, so thats why I reply to this post..

i have eggdrop 1.6.17 and i have problems with use-exempts and use-invites.

I've set these to 1 and uncomented them both... still when I use .+invite or .+exempt , the bot always responds with "you need to enable use-invites ...

I see it clearly set in my config file that I use within the bot, so I tried to enable the .set command in the console and I noticed this unbinding of these commands, tried to make them bind (as described in the previous posts) and still when restarting the bot it just won't work.. the bot still says "What ? you need help"...

what can this be ?

Statistics: Posted by CosmicD — Sat Dec 11, 2004 4:07 pm

use-exempts

2003-11-25T09:09:37-04:00

you have the followin in your .conf file:

unbind dcc n set *dcc:set

change it to

Code:

bind dcc n set *dcc:set

to let it work.

only in the confs where the .set command doesn't work (its already bound in your other bots)

Statistics: Posted by Sir_Fz — Tue Nov 25, 2003 9:09 am

use-exempts

2003-11-25T03:57:12-04:00

On some of my shells I can right from the partyline do ".set use-exempts 1" to enable ban exempts, however a few of them I can't, it doesn't recognize use-exempts from the .set command. And when I put "set use-exempts 1" in its config file, it ignores this. Why is this? Is there some ./configure option that enables it when you first compile it?

Statistics: Posted by Guest — Tue Nov 25, 2003 3:57 am