egghelp/eggheads community

setudef tips plesae

2010-09-11T17:29:35-04:00

Incredible! I am still learning a lot and haven't gotten to the "loops" yet

I really appreciate you guiding me with this nml375.

Statistics: Posted by kenh83 — Sat Sep 11, 2010 5:29 pm

setudef tips plesae

2010-09-11T13:22:43-04:00

Something along these lines:

Code:

...foreach channel [channels] {  if {[channel get $channel relaycommand]} {    #This channel is set +relaycommand, so do something here...    puthelp "PRIVMSG $channel :Woobie!"  }}

Statistics: Posted by nml375 — Sat Sep 11, 2010 1:22 pm

setudef tips plesae

2010-09-11T12:42:51-04:00

nml, i'm confused as to what you mean by loop through all the channels..

Could you kindly share an example?

I've dropped using 'args' in all of my scripts. Thanks for the tip!

Statistics: Posted by kenh83 — Sat Sep 11, 2010 12:42 pm

setudef tips plesae

2010-09-11T11:01:34-04:00

Pretty much anything...
"arg" or "text" would do just fine.

Statistics: Posted by nml375 — Sat Sep 11, 2010 11:01 am

setudef tips plesae

2010-09-11T10:13:30-04:00

What should be used instead of args?

Statistics: Posted by kenh83 — Sat Sep 11, 2010 10:13 am

setudef tips plesae

2010-09-11T09:28:22-04:00

kenh,
You could loop through all available channels, test each for the "relaycommand" status, and if set, issue the needed commands on that channel..

On a side-note, avoid using the name "args" in your argument list, as this word is handled in a different manner by tcl.

Statistics: Posted by nml375 — Sat Sep 11, 2010 9:28 am

setudef tips plesae

2010-09-11T08:29:31-04:00

yes, ceasar thank you for correcting that, but that is not my question or why I posted. Please re-read.

Statistics: Posted by kenh83 — Sat Sep 11, 2010 8:29 am

setudef tips plesae

2010-09-11T04:42:55-04:00

Replace:

Code:

setudef +relaycommand

with:

Code:

setudef flag relaycommand

You can replace relaycommand with anything as long as isn't used already.

Statistics: Posted by caesar — Sat Sep 11, 2010 4:42 am

setudef tips plesae

2010-09-11T08:29:52-04:00

Code:

setudef flag relaycommand bind pub - !command cmd:procproc cmd:proc { nick uhost hand chan args } {  if {[channel get $chan relaycommand]} {   putlog "detected !command and +relaycommand was set to this channel - $chan"  }}

is it possible in some way that i'm not able to figure out or find out by reading available documentation, to be able to add, beneath that "putlog" command, to use putallbots WITHOUT specifying a channel within the putall bots command .. and be able to have the other bot that receives the putallbots command be able to know which channel to send text to base off of 'setudef'

hopefully this make sense.. i really hope it does and that someone can shine some lite for me

Statistics: Posted by kenh83 — Fri Sep 10, 2010 11:40 pm